Special PTT Design Worksheet – Headset and Adapter

Special PTT Design

Customer Information

Host Application

Specify the type, manufacturer, and model number of the equipment with which this headset is to be used.

Microphone Characteristics

Does the microphone have noise cancelling?
Please select one of the below:

Push-to-talk Configuration

Push-to-Talk Switch
Trigger
Configuration

Headset Configuration

Speakers Required
Ear Cushions Required
Please tick the headset configurations that you require.

Volume Control

Do you require volume control?

Cable length (adapter to host)

Please choose a cable length you require.
Please choose a cable type.

Connector to Host

Please specify the manufacturer and part number of the connector that is required to connect the adapter to the host equipment. Please describe how the connector is wired by completing the table below.

Please choose a USB Type.
Does it require headset detection?

Connector Wiring

1. Depending on the connector, wiring is specified by referring to pin numbers (or letters) or connector parts (e.g., the tip, ring, and sleeve parts of a Plug-prong connector, like a PJ-7).
2. Please specify transmitter polarity if applicable, e.g., in the case of an electret mic.
3. A second receiver would only be specified in the case of a dual-channel headset.
4. A jumper wire or resistor is sometimes required in the connector to signal the host equipment that a headset is connected, commonly known as Automatic Device Detection (ADD).

Quantities

This form collects your name, email address, telephone number and message so that we can communicate with you regarding this form submission. Please check our Privacy Policy for more information about how we protect and manage your submitted data.
GDPR Consent *